How to Install BMW Door Lights By Yourself?

BMW Door Lights is wireless especially designed for BMW modification fancier. It will not destroy your original car appearance because it doesn’t need any drilling for your lovely car.

However, Firstly you need to buy one set of BMW door lights on the market or anywhere. Please pay attention that car door lights should without drilling on the car (Magnet Type). It doesn’t matter if you buy wrong type door lights that need drilling, you can check this article How to Install Ghost Shadow LED lights?

Types of BMW Car Door Projector Lights :

1. Magnet BMW door lights: It uses 3M tape to fix the lights on the door. This is also actually shown below for the installation.

 

2.Drilling BMW door lights: It needs to do the dilling on your door panel. The package includes the drilling tool.

 

3.Professional BMW door lights: Remove the original led lights from the door panel and replace it quickly by some simple tool.

 

 BMW Car Door Projector Lights Installation Step:

1. Remove the cover from ghost shadow lights and put on the battery inside of the lights housing. AAA  batteries 4.5V is needed. Your need to buy it in addition because typically lights seller doesn’t provide it.

2,  put the 3M tape one side on lights housing, You can get the tape from the lights together in the box which you bought. Let me give you a pointer. Make sure you cove the top area because the bottom area will be hanging out a little bit. The top area must get.

3. Put the BMW door lights on the door panel. Try to put it in vertical for the plastic housing. So this light will go inline here.

4, Put the projector film on the right position of the lights housing. Typically you can forget this step. Because the seller has already put the film inside of the lighting housing. But if you want to change other logos in the future, you can buy and switch to another film. Just replace it!

5. Cleaning your car doorstep where you want to install the BMW door lights. If you do not clean it before, the management could not stick on the step tightly and easily fall off after your finishing installation.

6, Remove the tape from the magnet and put the magnet on the step position when lights keep the distance from magnet longer than 1-   2cm.you go it’s finally installed as you can see the magnet is just a line under the sensor. It is fully intact, so when I’m going to open the door, you will see that the lights logo.

7, The dazzle BMW door lights logo will display on the ground when you open the door, and it will be turned off when you close the door.you can see it doesn’t look that bad either, especially in this bright light staff code, but it’s going to look even better when it’s outside in the dark.

It’s a knowledgeable method, and it requires literally.No hardware installation. No, bring up the door. Anything is cheaper, and it works well. It can be installed in both left and right doors, Courtesy door light makes your car artist moreover the atmosphere. It is improving the grade of your car. If you are a car decoration fan and want to do more high technology decors on the vehicle. Or buy more LED car tuning parts here www.carledlogo.co.uk/shop or www.carledlogo.de/turbeleuchtung,www.carledlogo.fr

Final Thoughts :

Different people have different thoughts. Some people buy the BMW door lights consider not only the easy installation but also the cheap cost. And they will choose the magnet type. But in the future, if you want to remove the 3M tape from your door panel, it could be a problem. From the professional decoration view, professional BMW door lights could be the best choice.